Hi all,
The last few lines on my Serial terminal looks something like this when I switch on the LPC2294 board given in this site.
PID hash table entries: 32 (order 5: 256 bytes)
Memory: 4MB = 4MB total
Memory: 3028KB available (849K code, 95K data, 44K init)
Calibrating delay loop... 0.81 BogoMIPS
Dentry cache hash table entries: 1024 (order: 0, 4096 bytes)
Inode-cache hash table entries: 1024 (order: 0, 4096 bytes)
Mount-cache hash table entries: 512 (order: 0, 4096 bytes)
POSIX conformance testing by UNIFIX
NET: Registered protocol family 16
Rtl8019as driver for Philips LPC2294: version 0.2
eth0: 12:34:56:78:90:ab
MMC/SD-Card Driver init OK
Using deadline io scheduler
Capacity 255 MB
bd0: p1 p2
Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing disabled
ttyS0 at MMIO 0x0 (irq = 6) is a 16550A
ttyS1 at MMIO 0x0 (irq = 7) is a 16550A
NET: Registered protocol family 2
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 512 bind 512)
EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended
VFS: Mounted root (ext2 filesystem).
Freeing init memory: 44K
and the board stops after this!!! The MMC access LED also stops after some blinking.
Are there anybody who has faced such issues or are there somebody who can give me some hints on to where I should have gone wrong?
Thanks in advance,
Balaji.V