ich wollte heute meine erste den uC bespielen aber leider kommt bei mir als Errormeldung nur :
So wie ich das deute liegt es an der Datei oder ? Bin noch relativ neu auf dem GebietC:\WinAVR-20081205\bin\avrdude.exe -q -u -C C:\WinAVR-20081205\bin\avrdude.conf -p m8515 -P /dev/parport0 -c usbasp -E noreset,novcc -U flash:w:I:\Download\led.hex:a
avrdude.exe: WARNING: -E option not supported by this programmer type
avrdude.exe: AVR device initialized and ready to accept instructions
avrdude.exe: Device signature = 0x1e9306
avrdude.exe: NOTE: FLASH memory has been specified, an erase cycle will be performed
To disable this feature, specify the -D option.
avrdude.exe: erasing chip
avrdude.exe: reading input file "I:\Download\led.hex"
avrdude.exe: input file I:\Download\led.hex auto detected as Intel Hex
avrdude.exe: writing flash (3088 bytes):
avrdude.exe: 3088 bytes of flash written
avrdude.exe: verifying flash memory against I:\Download\led.hex:
avrdude.exe: load data flash data from input file I:\Download\led.hex:
avrdude.exe: input file I:\Download\led.hex auto detected as Intel Hex
avrdude.exe: input file I:\Download\led.hex contains 3088 bytes
avrdude.exe: reading on-chip flash data:
avrdude.exe: verifying ...
avrdude.exe: verification error, first mismatch at byte 0x0000
0x11 != 0x00
avrdude.exe: verification error; content mismatch
avrdude.exe done. Thank you.
Gruß Pchero