hier ein AVR Ethernet Bootloader für das ArtNetNode, einmal eingespiel, benötigt man keinen Programmer mehr. Software Updates können dann in Zukunft via Ethernet eingespielt werden.
Gruß
Uli
Du hast keine ausreichende Berechtigung, um die Dateianhänge dieses Beitrags anzusehen.
Sorry for writing in English but my German is a bit rusty.
I don´t understand how this new version works.
Is there a instrution manual ?
With the normal hex file version 1.1 or 1.2 ???? from the project, as soon as i switch on the avr-artnet node, the two led´s blink two or three times and then i can send packets to it, and it is detected on the network.
Now I want to try the etherboot mode, but can´t get it to work. I flash the bootloader file but then the two leds flash uninterrupted, and i can´t find the art-net node on the network.
When i try the ethernet update tool to update to the version 1.5 ... what is the address ??
I set address 192.168.0 90 click update and get Fehler
Are there different pcb versions ? I mean the post from the 1.5 version just mentions older versions....
How many version are there ??
Thak you for your time
What´s the correct procedure ??
The bootloader has the default address 192.168.0.91. After power on the bootloader start and you can flash the art Net Node file with the AVR Ether Boot. The bootlader start for 6 secound every power on. After 6 secound the main programm (AVR Art Net Node) start up, when you have programm the main programm (AVR Art Net Node) with AVR Ether Boot. With the bootloader AVR Ether Boot you don't need a programmer everytime. You can flash new softwarefiles with the bootloader (AVR Ether Boot).
Hallo,
nochmal zur Sicherheit, kann ich mit AVR_EtherBoot einen ArtNetNode mit Version 1.2 auf 1.5 updaten? Wie groß ist das Risiko, daß dabei etwas schief geht?
Gruß Jens
Eine Frage uim Bootloader.
Ist die IP des Bootloaders immer die 192.168.0.91 ? Oder ist es die aktuelle IP des Node, wenn ich dem Node eine andere IP zugewiesen haben ?
Der Bootloader holt sich die IP aus dem EEPROM, also ist es auch die IP vom ArtNet Node.
Nur wenn der Inhalt vom EEPROM leer ist, ist es die Default IP!
welches Bootloader Programm wird benutzt??? Welcher Download von meiner HP würde man z.B. den Bootloader vom Mega128 von meiner HP verwenden gäbe es Probleme.
ich weiss ich bin schwer von Begriff, aber bevor ich mein ArtNetNode schrotte lieber nochmal nachgefragt:
Auf meinem Chip steht "1.5 Boot". Ich verstehe das so, dass der BootLoader bereits installiert ist.
Ich starte also AVR Ether Boot, wähle die IP meines ArtNetNode und das aktuelle Hex File "AvrArtNode_V3_4+Bootloader.hex" vom 09.07.2014 und alles wird gut?