Homepage

  • Projekte
  • Shop
  • Forum
Erweiterte Suche
  • Schnellzugriff
    • Unbeantwortete Themen
    • Aktive Themen
    • Suche
  • FAQ
  • Anmelden
  • Registrieren
  • Foren-Übersicht
  • Suche

Fuses in atmel studio 6.1

Antworten
  • Druckansicht
Erweiterte Suche
1 Beitrag • Seite 1 von 1
RickAT
Beiträge: 1
Registriert: 18.06.2013, 23:00:52

Fuses in atmel studio 6.1

  • Zitieren

Beitrag von RickAT » 22.06.2013, 09:24:47

hello,

I have to do this in English because my Deutsche is very bad.

i have made this LED board, but i changed the smd MCU for a through hole attiny2313.
so my PCB became one layer with 3 wire bridges.

I uploaded the hex file but the output is very strange, and not according the input signal.

Now i think its because i do something wrong with the fuses, could you tell me which fuses i have to select in Atmel Studio 6.1 and what CKSEL I have to chose? I use the avrisp MKII programmer.

attatched are my eagle files, maybe i did something wrong there
schema.png
board.png
I hope you can help me


Thanks in advance,
Rick
Du hast keine ausreichende Berechtigung, um die Dateianhänge dieses Beitrags anzusehen.
Nach oben

Antworten
  • Druckansicht
1 Beitrag • Seite 1 von 1

Zurück zu „DMX RGB LED Strip Controller / RGBW+ Controller“



  • Foren-Übersicht
  • Alle Zeiten sind UTC+02:00
  • Alle Cookies löschen

Powered by phpBB® Forum Software © phpBB Limited

Deutsche Übersetzung durch phpBB.de

Datenschutz | Nutzungsbedingungen

 

 

sitemap  |    |  datenschutz   |  impressum